Brookfield DV2+Pro Viscometer Bedienungsanleitung PDF herunterladen (Seite 38)

Brookeld Engineering Labs., Inc. Page 38 Manual No. M03-165-F0612

printmodeandnallyinitiateeitherofthetimedmodesofoperation.Whilesetting

up the timed mode parameters, continuous print operation will cease. However, upon

starting the timed operation, the DV-II+Pro will output an initial data string to the printer

andthencontinueprintingdatastrings(attheuserdenedtimeinterval)fortheduration

of the timed run. At the end of the timed run, continuous printing will again be disabled

andtheusermayprintsinglestrings(ofthenaldatapoint)atyouroptionuntilyouexit

the timed mode. Upon returning to the default operation mode, continuous printing will

again resume at the user selected time interval. In a similar manner, if you are in the

once-per-

PRINT -key-press mode, when you enter the timed mode of operation you will

be able to print data strings at any time during the timed mode by pressing the

PRINT key.

IV.3.3 Print Time Interval

This option is used to set the print time interval to the selected printer. Scroll to Set Print Time,

asshowninFigureIV-29:

DTIMED TO TORQUE

SET PRINT TIME

Figure IV-29

PresstheENTER/AUTORANGEkey.Onentry,FigureIV-30isdisplayed:

PRINT INTERVAL

SET MIN’S: 00 ↑↓

Figure IV-30

Using the UP and DOWN ARROW keys, enter a value for the minutes between successive print strings.

Thisvaluecanbeashighasfty-nine(59)minutesandaslowas00.

Whensatised,presstheOPTIONS/TABkeytoenterthesecondssettingdisplay:

PRINT INTERVAL

SET SEC’S: 00 ↑↓

Figure IV-31

Using the UP and DOWN ARROW keys, enter a value for the seconds portion of the print interval.

Thisvaluecanbebetweenzero(0)andfty-nine(59)seconds.

Note: The value for minutes or seconds must be other than zero (0) or

you will print continuously when you exit this mode. A press of

the MOTOR ON/OFF/ESCAPE key would exit this option and

take you back to the screen of Figure IV-29.

Continued pressing of the OPTIONS/TAB key will toggle between the minutes and seconds input

screens. Press the ENTER/AUTORANGE key to accept the new values for print interval in minutes and

seconds.YouwillnowbeinthescreendisplayofFigureIV-29whereyoumayre-entertheprint

interval mode, or exit to the default screen (Figure II-5) by pressing the MOTOR ON/OFF/ESCAPE key.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 100 101

Keine Kommentare

Brookfield DV2+Pro Viscometer Bedienungsanleitung Seite 38