Brookfield DV2+Pro Viscometer Bedienungsanleitung PDF herunterladen (Seite 31)

Brookeld Engineering Labs., Inc. Page 31 Manual No. M03-165-F0612

AUTORANGEkeytoselecttheashingoption.

DCGS UNITS

DSEQUENTIALê

DCGS UNITS

DINTERLEAVE

DCGS UNITS

DCUSTOM SPEEDSê

Figure IV-9

The speeds available in each of the above options are listed in Appendix G. The DV-II+Pro is

initiallysetupwiththeSequentialSpeedSetatBrookeldpriortoshipment.

IV.2.3.1 LV/RV Speeds

In the case of Sequential or Interleave, a press of the

ENTER/AUTORANGE key immediately selects

that option and exits the SETUP option menu.

IV.2.3.2 Custom Speeds

Pressing the

ENTER/AUTORANGE key when Custom Speeds is displayed results in the following

screendisplay:

.01 h

°0.0 i

Figure IV-10

Fifty-four(54)speedsareavailableforcustomspeedsetselection(seeAppendixG).Youare

allowed to select up to nineteen (19) of these (54) available speeds. Speed 0.0 is automatically

included as one of the nineteen (19) speeds. Selecting a speed (or deleting a speed) is accomplished

by pressing the SET SPEED key while the desired speed is blinking. This will cause an asterisk

to appear (or to disappear if the speed is being cleared) to the left of the speed. Trying to select

more than nineteen (19) speeds will result in a “beep” for each press of the SET SPEED key when

overthislimit.Youmayscrollupordownthroughthespeedsetinselectingspeeds.Whendone,

a press of the ENTER/AUTORANGE key will take you back to the default screen with the asterisked

speeds now comprising the custom speed set. Regardless of order chosen, speeds will appear in

ascending order for run selection, beginning with speed 0.0 RPM.

IV.2.4 Printer Output Port

Scrollingtotheprinterportoptionpresentsthefollowing:

DSEQUENTIAL

DPRINT SERIAL

DSEQUENTIAL

DPRINT PARALLEL

Figure IV-11

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 100 101

Keine Kommentare

Brookfield DV2+Pro Viscometer Bedienungsanleitung Seite 31