Brookfield CT3 Texture Analyzer Bedienungsanleitung PDF herunterladen (Seite 44)

Brookeld Engineering Labs., Inc. Page 44 Manual No. M08-372-C0113

ACCESSORIES FOR FIXTURE BASE TABLE

TA-BT-KIT FIXTURE BASE TABLE

Rectangular base table with removable insert, which is used as a test surface. All

accessories listed below mount into this table when the insert is removed. Pair of

T-Bolts for securing the table are included. Four sets of extension legs (1, 1.5, 2

& 4 Inches) are supplied. Extra extension legs may be purchased separately.

TA-BT-3KY Set of four 1 inch table leg extensions

TA-BT-2KY Set of four 1.5 inch table leg extensions

TA-BT-7KY Set of four 2 inch table leg extensions

TA-BT-8KY Set of four 4 inch table leg extensions

TA-BT-6KY Set of two thumbscrews for base table insert

ALL ACCESSORY FIXTURES BELOW MOUNT ONTO FIXTURE BASE TABLE

TA-AACC21 AACC RECOMMENDED 21mm DIAMETER PROBE

Aluminum Cylinder, 21mm D and 40mm L. Requires Fixture Table Base TA-

BT-KIT.

TA-AACC36 AACC SPEC PROBE (36mm)

Thisprobeisusedformeasuringbreadrmnessandperformingtextureprole

analysis (TPA). Requires Fixture Table Base TA-BT-KIT.

TA-BLS BILAYER SHEAR TEST FIXTURE

Thisxtureusesaguillotinebladetoseparateabilayertabletwhilemeasuring

shear strength. Requires Fixture Base Table TA-BT-KIT.

TA-BPS BLISTER PACK SUPPORT TEST FIXTURE

Thisxtureisusedtomeasuretheforcerequiredtoremovethetabletfromits

blister pack. Requires Fixture Base Table TA-BT-KIT.

TA-CEF CHEESE EXTENSIBILITY FIXTURE

Thisxturemeasurestheextensibilityofasmaple,suchasmoltencheese,to

break point.

TA-CJ CONFECTIONERY JIG

This xture is used for holding candies and similar products for penetration

testing. Requires Fixture Base Table TA-BT-KIT. Consists of bases and top

plates with holes 4mm, 8mm and 12mm in diameter to allow through penetration

of samples with probes slightly smaller than holes. One blank plate (no hole) is

also included to serve as a test surface when needed.

TA-CKA CRAFT KNIFE ADAPTER

This adapter cuts cleanly into and through material with minimum deformation

of the sample. Requires Fixture Base Table TA-BT-KIT.

TA-CLT CAPSULE LOOP TENSILE TEST FIXTURE

Thisxtureisusedtomeasuretheforcerequiredtosplitonhalfofahardgel

capsule. Requires Fixture Base Table TA-BT-KIT.

TA-CSF CIRCULAR SUPPORT FIXTURE

Thisxtureprovidessupportforroundsamplesandretainsanypotentialuid

expressed during the test. Requires Fixture Table Base TA-BT-KIT.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Brookfield CT3 Texture Analyzer Bedienungsanleitung Seite 44

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Messgeräte Brookfield CT3 Texture Analyzer