Brookfield CT3 Texture Analyzer Bedienungsanleitung PDF herunterladen (Seite 20)

Brookeld Engineering Labs., Inc. Page 20 Manual No. M08-372-C0113

Deformation and Load will remain live displays during the test. When the countdown clock reaches

zero, the probe returns to home/starting position at 4.5mm/s.

Testresultsareshownonthereportingscreen:

HOLD TIME: XXXX S

PEAK LOAD: XXXX.X g

DEF@PEAK: XXX.X mm

FINAL LOAD:XXXX.X g

TEMP: XXX.X F

III.11

Peak load usually occurs at the target deformation, but may occur before the target is reached.

Final load is the load recorded at the end of the hold time and is usually lower than the peak due

to sample relaxation.

CYCLE COUNT TEST – performs a programmed number of compression cycles upon a

sample.

The operator sets the number of cycles, trigger value, target deformation and test speed using the

CycleCountmenuscreen:

TEST: CYCLE COUNT: XXXX

TRIGGER: XXX.X g

DEFORMATION :XXX.X mm

SPEED: XX.X mm/s

III.12

When the operator depresses the start button, the cycle count test performs multiple compressions

on a sample at the programmed test speed to the target deformation, then returns immediately to

home/starting position. Return travel speed for each cycle is the same as compression speed.

Duringthetesttherunningscreenisseenasshownbelow:

TEST: CYCLE COUNT: XX

DEFORMATION: XXX.X mm

LOAD: XXXX.X g

III.13

Cycle count will show a count down of the number of cycles remaining. Deformation and Load

will remain live displays during the test.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

Keine Kommentare

Brookfield CT3 Texture Analyzer Bedienungsanleitung Seite 20