Brookfield CAP2000 Viscometer Bedienungsanleitung PDF herunterladen (Seite 11)

Brookeld Engineering Labs., Inc. Page 11 Manual No. M02-313-G0812

HOLD TIME

This key selects time entry mode (wait time before spindle rotates).

SPINDLE

This key selects the cone spindle entry mode.

TEMP

This key selects the temperature entry mode.

I.8 Viscosity and Temperature Display

Viscosity is displayed in either P=Poise or cP=Centipoise (CGS system) or Pa•s=Pascal

seconds or mPa•s=milliPascal seconds (SI system). If the viscosity measurement is over

range, “EEEE” will be displayed. Brookeld recommends a minimum torque reading of 10%

when making viscosity measurements. If the torque value is between 0 and 10%, the display

will ash to indicate an under range condition. If the viscometer nal reading is below zero,

negative values will be displayed.

Temperature is displayed in °C=degrees centigrade.

I.9 Cleaning

Instrument, Keypad & Painted Surfaces:

Clean with dry, non-abrasive cloth. Do not use solvents or cleaners.

Immersed Components (spindles/cones) and temperature controlled plate:

Note: Sample plate and spindle may be hot. Use care when using solvents.

All immersed components are made of carbide steel. Clean with non-abrasive cloth and

solvent appropriate for sample material that is not aggressive to immersed components.

Do not use metal objects to clean the plate surface, as scratching of the plate may occur

and comporomise cone calibrations.

Solvent Trap:

Solvent Trap (P/N C1K-63) is made of Teon. Clean with non abrasive cloth and solvent

appropriate for sample material that is not aggressive to Teon.

Do not use metal objects to clean the plate surface, as scratching of the plate may

occur and compromise cone calibrations.

Immersed components (cone spindle) may be at an elevated temperature. Use caution

when cleaning hot surfaces. Use caution when applying solvents to hot surfaces. Refer

to the MSDS for the specic solvent for proper handling techniques.

Note: When cleaning, take care not to apply excessive force which may bend the spindle

shaft or otherwise damage the instrument.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 36 37

Keine Kommentare

Brookfield CAP2000 Viscometer Bedienungsanleitung Seite 11